How To Install a Power Pin to a Tregaskiss MIG Gun
- Thread the power pin into the rear housing.
- Tighten the power pin into the rear housing using a 1-inch (2.54 cm) wrench on the rear housing and a 3/4-inch (19 mm) wrench on the power pin. Torque to 18 ft.-lbs. (24.4Nm).
- IMPORTANT: The thread-in two-piece power pin has a taper to seat and lock the power pin in the rear handle block. Tighten the power pin in the block with a wrench to ensure that the pin remains in place.
- Install the liner.
![How To Install a Power Pin to a Tregaskiss MIG Gun](https://sp-ao.shortpixel.ai/client/to_webp,q_glossy,ret_img,w_469,h_284/https://www.tregaskiss.com/wp-content/uploads/2020/07/power_pin_installation_1.png)